Popular searches
Trending now Best sellers
Shop by category
The XR Pumping Master is an automatic penis pump that does the work for you: instead of squeezing a hand bulb, you press plus and minus buttons to choose one of five suction levels. A small screen shows the pressure in pascals, and a release button lets the vacuum go instantly. It's a rechargeable, all-in-one unit with a clear cylinder, a silicone entry sleeve and a connecting hose.
The clear cylinder is 8 inches deep and 2.35 inches across, with a textured outside so you can hold it steady and printed measurement markings along the side. At the open end sits a stretchy silicone sleeve with a 0.75-inch opening when unstretched. That snug opening is what creates the seal around the base of the penis so pressure can build. An 8.75-inch hose links the cylinder to the motorised pump unit, which holds the buttons, display and release valve.
Trim or shave the hair around the base so the sleeve can seal cleanly, then spread a little water-based lube on the inside of the sleeve and the skin it will touch. Slide in, press the cylinder gently against your body and start on level one. Let the pressure build for a minute or two before stepping up. The sensation is a pulling, tight fullness; it should never be painful. Keep early sessions short, and press the release button straight away if you feel pain, numbness, or see unusual colour changes or tiny red spots on the skin.
XR doesn't publish usage time limits, so err on the side of short sessions and low levels. Don't fall asleep with the pump on, and don't use it on broken or irritated skin. If you take blood thinners or have a circulation or bleeding condition, talk to a doctor before using any vacuum pump.
The Pumping Master suits people who want consistent, measurable suction without hand fatigue, and who like a clear readout of what level they're on. It's less suited to anyone whose girth is near or over 2.35 inches, since the cylinder diameter is fixed; a manual pump with interchangeable cylinders from our Size Matters range offers more sizing choice. Purists who prefer fine, hand-controlled pressure may also find five preset levels limiting. On the plus side, the button control means you can keep one hand free and stay at a steady level rather than drifting higher as you squeeze.
The pump unit charges by USB, so there are no batteries to replace. After use, pull the silicone sleeve off and wash it and the cylinder with warm water and mild soap or toy cleaner, then let them dry fully before reassembling. Keep the motor unit and hose dry; wipe them with a damp cloth only, as XR doesn't list a water rating for the electronics.
Explore more penis pumps, or see our guide to male sex toys.
Helpful answers about XR Pumping Master Rechargeable Automatic Penis Pump.
To use the XR Pumping Master, lube the silicone sleeve, slide in, press the cylinder gently against your body and choose level one with the plus button. Step up slowly while watching the pressure display. Press the release button to let the vacuum go before you pull the cylinder off.
The Pumping Master has five suction levels, set with plus and minus buttons, and a screen that shows the internal pressure in pascals. Noting the reading you're comfortable with makes sessions repeatable. Always start at level one, even if you used a higher level last time.
The Pumping Master cylinder is 8 inches deep and 2.35 inches in diameter, and the silicone sleeve opening is 0.75 inches unstretched. If your erect girth is close to the cylinder width, there won't be room to pump comfortably. In that case, choose a pump with a wider, swappable cylinder.
The XR Pumping Master is easy for beginners to operate because the levels are preset and the release button is instant. Use the lowest level, keep sessions short and stop at any pain, numbness or skin spotting. Check with a doctor first if you take blood thinners or have circulation problems.
Use a water-based lube with the Pumping Master, applied inside the silicone sleeve and around the base of the penis. It helps the sleeve seal and slide comfortably. Silicone lube can degrade the silicone sleeve, and oil-based products are harder to wash out of the cylinder. A thicker gel holds a better seal.
No, keep the Pumping Master's motor unit and hose out of water, since XR doesn't list a water rating for the electronics. The clear cylinder and silicone sleeve can be removed and washed with warm soapy water. Wipe the pump unit with a damp cloth and let everything dry before reassembling.