Popular searches
Trending now Best sellers
Shop by category
The XR Milker Extreme 16X is a motorized male masturbator that sucks, squeezes and vibrates. Inside a hard ABS case sits a soft, removable TPE sleeve with a realistic ridged tunnel, and the motor gives you 3 suction modes, 3 squeezing modes and 10 vibration modes to use alone or together. It suits anyone who wants an automatic stroker for edging and longer sessions, where the toy does the work and you control the build.
Each function feels different. Suction pulls the sleeve against you in waves, so it feels like being drawn in. Squeezing tightens the sleeve rhythmically around the shaft, a firmer, gripping sensation. Vibration adds a buzz through the whole tunnel. You can run any one on its own, combine suction and squeezing, or layer all three. Most people find it more interesting to change things up mid-session than to leave everything on full.
There are four controls. The Cloud button cycles through the 3 suction modes, and holding it for 3 seconds stops suction. The Squeeze button does the same for the 3 squeezing modes. The Squeeze2 button on top runs 3 modes of squeezing and suction together; hold it for 3 seconds to stop both. The Manual button on the side runs vibration, suction and squeezing at once for as long as you hold it down, and everything stops when you let go. That press-and-hold control is handy for edging, because releasing it gives you an instant pause.
Squirt water-based lube into the tunnel and spread more on yourself. Start with gentle squeezing and slow, short strokes while you warm up. Add a low suction mode and play around the edge of each intensity, then bring in vibration with the Manual button when you want a peak. When you get close, let go and drop back to squeezing alone, then build again. Repeating that cycle a few times usually makes the finish stronger.
The case is 10.8 inches long and 3.6 inches wide, with 5.5 inches of insertion length. The TPE tunnel is soft and stretchy with ridges and curves, so it adapts to a range of girths. If you're longer than 5.5 inches, you'll reach the end. It's a two-handed toy for most people, or rest it against a pillow and thrust.
Charging uses the included USB cable, which attaches magnetically to the case. A full charge takes about 2 hours, and XR advises not charging for more than 2 hours, to protect long-term battery life. XR doesn't list a run time or a water rating, so keep the case dry. To clean, remove the sleeve, wash it in warm water with soap, spray it with toy cleaner, rinse and let it air-dry fully before refitting it. Wipe the case with a damp cloth only. Use water-based lube only: XR says other types can damage the TPE.
Compare more male masturbators, stock up on masturbation lube, or read our guide to automatic strokers.
Helpful answers about XR The Milker Extreme 16X Sucking Male Masturbator.
Suction creates a pulling sensation, as if the sleeve is drawing you in, pulsing in waves. On the Milker Extreme, you can pair it with rhythmic squeezing and vibration, which together feel closer to oral sex than a manual sleeve. Start low, since suction builds quickly.
Cloud cycles 3 suction modes, Squeeze cycles 3 squeezing modes, and the top Squeeze2 button runs 3 combined modes. Hold any of them 3 seconds to stop that function. Hold the side Manual button to run everything together, and release it to stop.
About 2 hours with the included magnetic USB cable. XR advises not charging for more than 2 hours to protect the battery. A run time per charge isn't listed, so charge it fully before a long session.
XR doesn't list it as waterproof, and the motor sits in the case, so keep the case away from water. Only the removable TPE sleeve should be washed under the tap. Wipe the case with a slightly damp cloth instead.
No. XR says to use water-based lubricant only. Silicone and oil-based lubes can damage the TPE sleeve. A thicker water-based lube helps suction work better and lasts longer; see our masturbation lubes.
Yes. The press-and-hold Manual button gives you all three functions while held and an instant stop when released, which suits edging. Build up with squeezing and suction, add vibration near the peak, then let go and back off.
Pull the TPE sleeve out of the case, wash it in warm, soapy water, spray with toy cleaner and rinse. Let it dry completely, inside and out, before putting it back. Refitting a damp sleeve traps moisture against the case.
Expert guidance to help you choose, use and care for your products with confidence.